Build Your Own Clone Message Board

It is currently Fri Apr 19, 2019 5:02 pm

All times are UTC - 6 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Spring Reverb tone
PostPosted: Fri Mar 08, 2019 11:14 pm 
Offline

Joined: Thu Mar 07, 2019 2:18 pm
Posts: 2
Hi!
I am completely loving my new spring reverb! BTDR 3H. Easy to put together, and sounds amazing. I read on a previous thread about changing C3 to a .1 cap to let more bass pass through. The stock value is .01. Can I safely assume that replacing C3 with a .047 would allow about half as much through?
Second question: I was curious if the way to get variance in the clean/wet ratio would be to add one of the blend pot circuits you sell? The pot would probably come out the batt end as the pedal would sit on the amp and be in use all or most of the time. Which leads to my third question, if you have the patience.
Is there anything one could do to optimize this circuit to run between a tube preamp and an 80 watt power amp. Like say a sms ctp and a Mosvalve 962?
Thanks!
Jimbo


Top
 Profile  
 
 Post subject: Re: Spring Reverb tone
PostPosted: Fri Mar 08, 2019 11:30 pm 
Offline

Joined: Thu Mar 07, 2019 2:18 pm
Posts: 2
Oh, for the last question, that's 20K output from the pre into 50K ohm input impedance on the power amp. Thanks.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group