Build Your Own Clone Message Board

In another post (viewtopic.php?f=9&t=59519&p=498264&hilit=tinker#p498264) this person wanted to add boost before the Klone side instead of after as the circuit is designed. The answer was yes and there is a link (and photo) of that very mod performed on a OD2 build. I am wanting to do this same mod to the SP II that I am currently building. I have included a photo of my perception of how that mod should be applied to the SP II along with the one from the OD2 build. Could somebody look over my drawing and see if I have interpreted the mod correctly? Thank you all, in advance, for your assistance!

-=SteveO

_________________
“To know, and not to do, is not to know”

Looks good except for the extra wire you show between lugs 8 and 3 of the Boost switch.

_________________
“My favorite programming language is SOLDER” - Bob Pease (RIP)

My Website * My Musical Gear * My DIY Pedals: Pg.1 - Pg.2

Thanks Bob! I'm not sure where that came from. I do appreciate you taking the time to look at that for me. I figured it would be easier for me to follow if I actually laid it out in photoshop.
I'll erase the extra wire. print my diagram and get to wiring. I have the 3rd switch installed and the pcb mounted on the pots etc.
Once again, thank you!

-=SteveO

_________________
“To know, and not to do, is not to know”

Here is the corrected photo in case anyone else needs it in the future.

-=SteveO

_________________
“To know, and not to do, is not to know”