Build Your Own Clone Message Board

I have an original Analog Vibrato PCB (2006 Build Doc) and I am trying to source the stereo jacks that work with this board. I realize they are Neutrik but trying to make sure I get the right ones since I see there are a few options.

Any help would be greatly appreciated

Thanks!

They don't need to Neutrik. Any "standard" stereo switching 1/4" (6.35mm) PC mounted jack will work. I think you will see most of these types of jacks referred to as "Marshall" jacks as they are the type used in Marshall-style amps. The pin spacing should be the same across all brands. Where you will encounter a difference is in the bushing/nut. Marshall style tend to have a nut that threads on the inside of the bushing, whereas the Neutrik thread on the outside. Doesn't make a difference. It's just something to consider when drilling your enclosure.

_________________
*patience is a virtue*

Please do not PM me. email is prefered. keith@buildyourownclone.com

Thanks for the info

Maybe I was just overthinking it. I went to Smallbear to order some and saw they had had a few with different suffixes and I starting questioning it.

https://smallbear-electronics.mybigcomm ... -nmj6hcd2/

I assume these are just the standard normalled ones......?

I dont plan on using the battery connection but dont have an issue with getting extra support with the 6 lugs for stereo ones.

Yep. That jack would work

_________________
*patience is a virtue*

Please do not PM me. email is prefered. keith@buildyourownclone.com