Hi Everyone,
I am building a pedal that combines the Stereo Flanger and the Bass Chorus in the same box with a pedal switcher. I drilled a custom case. I am having troubles with the Stereo Flanger side.
Background InformationBypass on both side works
Bypass on both sides work with the order selector in any order (Stereo Flanger first or Bass Chorus first)
Bass Chorus side works fine in any order
When the Stereo Flanger is engaged, with or without the Bass Chorus and in any order, the signal pretty much disappears.
All of the pots are wires for both pedals and not directly connected to the PCB.
Troubleshooting thus farI search the PCB, switches, and pots for short to ground. I did not notice any.
I did notice that one of the BBD chips isn't fitting properly into the chip socket. Perhaps this is the issue.
I also noticed a slight thumbing sound / faint ossilation when I turn the amp attached to the pedal up. I only notice this when the Stereo Flanger is engaged. I can also faintly hear the guitar when the amp is turned up.
I'm not sure if this is a bias issue. The bias pot says 15x on it.
Photos can be viewed at the following link.
linkI would appreciate input.
Thank you,
Jon