Hello everybody.
First time noob poster here. Completed my first build about a week ago, but have been trying to troubleshoot it to no avail.
It's the BYOC 27v boost kit, a link to the schematic can be found here:
http://byocelectronics.com/27vboostschematic.pdfThe signal comes through and works fine in bypass mode, but when engaged, there's sort of a farty crunch sound, and you only hear anything when the notes are strummed pretty hard. And the notes die off quickly, almost like there is some sort of gate.
What I have done so far is checking all the joints and connections, making sure there are no bridges, double checking the correct resistors are in the correct slots. Ive gone through with an audio probe and the signal seems fine up until it gets into IC1 on pin 3. The signal coming out of IC1 pin 1 & pin 2 is the bad sound.
Here are the voltages I am seeing
IC1 TL072
P1=7.85
P2=7.56
P3=7.11
P4=7.56
P5=7.85
P6=7.87
P7=7.88
P8=8.66
IC2 7660S
P1=9.45
P2=8.99
P3=0
P4=seemed to fluctuate from about 8.3 -> 6.05
P5=7.56
P6=6.3
P7=9
P8=9.45
The 2 Diodes
D1
A=9.45
K=9.05
D2
A=9.05
K=8.66
9.45 Volts from the positive power circuit board connection.
I posted this problem on another forum and was led to believe it is very possibly an issue with the supply regulator IC, not seeing any 18v or -9v anywhere.
Checked a few times all the connections there and seems to be ok.