Ok, thank you for that clarification.
I mixed my words up a little in original post, and I meant to say that the green Pony and OD-820 each have a low pass filter (I said high pass). Only the TS did I think have an HPF.
In the green Pony, there is the switch which adds more/less capacitance in the rc filter I was referring to, and that, I believe is the low pass filter.
But as far as the TS goes, I was looking at the schematic from electrosmash, and the clipping section(attached here) has the capacitor(C3) and resistor(R4) in the same spot as the green pony. They are comparable values too. The difference as I see it the resistor and capacitor are swapped.
I am no circuit wizard of though, I feel like I am still missing or misunderstanding this in some way, so I appreciate any correction, that's the only way I'll figure this stuff out.
Attachment:
Screenshot_20231213-213249.jpg [ 61.78 KiB | Viewed 3328 times ]
Attachment:
Screenshot_20231213-213058.jpg [ 71.5 KiB | Viewed 3328 times ]
Sent from my Pixel 2 XL using Tapatalk